Fault Analysis Of Multi-channel Rotary Joint

Jan 16, 2024

Most failures of multi-channel rotary joints are caused by mechanical seal failure. When the medium leaks into the cavity from the sealing element, it will contaminate lubricating grease, corrode internal components, accelerate bearing wear, and cause operational failures.

During use, the wear and leakage of the joint seal should be regularly checked. If the leakage is large, the sealing components should be replaced in a timely manner to ensure the normal operation of the joint.

The common faults of multi-channel rotary joints mainly include the following aspects:

1. After using the rotary joint for a period of time, natural wear will occur, and the wear on the sealing surface and bearings is generally more obvious;

2. The mismatch of the stop mechanism resulted in mechanical failure of the multi-channel rotary joint;

3. Malfunctions caused by incorrect installation, misalignment of pipes and joints, or incorrect thread direction;

4. The use of rigid connections results in poor stress or excessive vibration of the multi-channel rotary joint, causing damage;

5. Improper selection during procurement, inconsistent performance between operating conditions and multi-channel rotary joints, and joint damage caused by high temperature or high pressure.

 

1-21020P01426001

Of course, the factors that can cause multi-channel rotary joint failures vary from person to person and are diverse, and specific problems still need to be analyzed.