Precautions For Replacing The Rotary Joint

Aug 13, 2025

 

Prioritize Safety to Eliminate Risks

Before replacement, cut off the power sources of the equipment (such as motors and power supplies), close the medium supply valve, and completely drain residual medium in the pipeline. Meanwhile, confirm that the pipeline pressure is 0 to prevent leakage, accidental startup of equipment, or medium spray injury during replacement.

Preprocess Pipes to Ensure Cleanliness

Ensure the inside of the pipeline is clean and free of foreign objects to prevent impurities from entering the new joint and causing damage or leakage. Also, check that the pipe section is vertical, and the pipe mouth is free of scratches, deformation, or other damages. Unqualified pipe mouths are prohibited from use to avoid affecting the sealing effect.

Air Rotary Joint Introduction
Air Rotary Joint Introduction 1

Strictly Match Models and Corresponding Parameters

The new joint must be completely consistent with the old one in terms of parameters such as interface specifications (thread/flange size, sealing form), rated pressure/temperature, medium compatibility (e.g., corrosion resistance), and speed range. This prevents installation failure or operational faults due to mismatched models.

Standardize Installation and Focus on Details

During installation, ensure the joint is concentric with the equipment's rotating shaft/pipeline to avoid eccentricity or inclination (otherwise, it may accelerate wear and cause seal failure). The tightening force of the interface should be moderate-over-tightening may damage the seal, while under-tightening may cause leakage.

Test Run and Inspection to Ensure Stability

After installation, conduct a low-pressure test run first to check for medium leakage, abnormal vibration, or unusual noise. After running for a period, shut down the equipment to recheck the tightness of the interface and the sealing status. Only put it into normal use after confirming there are no hidden dangers.

1754457644
 

In addition, in daily use, avoid long-term overloading of the rotary joint to extend its service life.