The reason for the leakage of the thermal oil rotary adapter just after use

Jan 02, 2024

According to the different transmission media, different rotary joints can be selected. For example, when transmitting liquid media such as water, oil, or hot oil, thermal oil rotary joints can be used. However, many times, leakage occurs at the beginning of use. What is the reason for this?

The leakage is mainly caused by the presence of hard particles or other debris in the transmission medium. Before connecting the medium fluid pipeline, it is necessary to clean the pipeline, drum, and the inside of the thermal oil rotary joint. Impurities in the medium can cause the sealing failure of the rotary joint, and the filtration accuracy of the medium also determines the service life of the joint seal. It is recommended that the filtration accuracy is not less than 50 microns. The higher the filtration accuracy, the better the service life of the rotary joint.

1-21020Q04420-50001

If it is a rotary joint for gas transmission, it is recommended to install an oil mist atomizer to allow the compressed air to contain atomized lubricating oil, indirectly lubricating the sealing surface of the joint and improving its service life; Usually, the transmission medium of rotary joints is divided into two categories: liquid and gas. It is recommended that you clean the connecting device and rotary joint before installing and using thermal oil rotary joints to avoid the above-mentioned leakage faults.